This is bad, m-kay? Two different cases. The first was a bit hotter load then the second This was produced in trying to make a XD 5" .40S&W run with a 9mm conversion barrel made by bar-sto. The barrel does not appear to be functional as the ramp is cut too deep into the chamber leaving the casing unsupported. This was make when trying to get the pistol to cycle with a compensator. The second case was a normal power round, the red circle indicates a bulge. It is difficult to show on camera but is obvious to inspection by a finger. The first case had a bit more behind it.
No comments:
Post a Comment